Identify the affected assembly
When a weld fails an agreed check, record the part mark, heat identity, drawing revision, weld location and inspection result. Do not begin rework from a verbal instruction alone; the approved repair route depends on the actual joint and service requirement.
Obtain the repair decision
The responsible welding engineer should approve removal method, preparation, filler and procedure requirements for the specific A588 grade and assembly. A supplier or inspector should not assume the original procedure covers every repair geometry.
Preserve traceability through rework
Keep the plate and assembly identification visible or use a controlled temporary record while grinding, cutting or cleaning. Log who performed the repair and the materials used. If the repair changes dimensions or an exposed face, return that change to the project reviewer.
Reinspect the right scope
State which visual, dimensional or nondestructive examinations are repeated and their acceptance basis. Link the new results to the original nonconformance and repair record. A passed repair is only as clear as the documented location and method.
Protect the final handover
Update packing and closeout records so the receiver knows which assembly was repaired and accepted. Any remaining appearance, coating or fit exception should be resolved in writing before dispatch or installation.
Send the right information
See the related product inquiry and product directory, or send the approved specification and drawing for a scope review.