Request splice plates against an approved connection drawing and a component schedule. The supply can cover agreed cut blanks or plates with specified drilled or cut features, subject to fabrication review. Connection design, material suitability and the fastening arrangement must be established in the project documents before production release.
Provide the joint and loose-part drawings
Show plate thickness, outline, hole sizes, hole coordinates and viewing direction. Include the mating-member references so the fabricator can understand which pieces form a set. Where opposite-side plates differ, identify their hands separately. Do not rely on a generic connection picture to define the required spacing, edge distances or plate capacity.
Agree the hole-production and fit requirements
State the required hole condition, inspection scope and any restrictions from the project specification. Ask the processor to confirm the proposed route for the actual material and geometry. Define whether supplied pieces are interchangeable or matched to particular members, and whether a template check or trial assembly is included. Any change affecting the connection requires the accepted project approval route.
Specify contact and exposed surfaces
Distinguish the joint contact faces from surfaces exposed to view. The connection designer determines any relevant surface preparation or protection requirement. Keep that requirement in the purchase scope rather than assuming that an outdoor weathering finish is also suitable for every concealed interface. Any cleaning, edge finishing or additional treatment should be named in the quotation.
Preserve set identity at delivery
List the joint reference, plate mark, quantity and supplied accessories for each set. Retain material traceability and the agreed dimensional records. Mark or label the pieces using an accepted method and package incomplete sets visibly if split delivery has been agreed. Fasteners, installation and structural verification are included only when specifically stated in the accepted supply scope.
Information for a splice-plate offer
| Item | Information to define |
|---|---|
| Connection | Approved joint and mating-member references |
| Plate | Material, outline and thickness |
| Holes | Pattern, datums and production requirement |
| Faces | Contact-surface and visible-finish scope |
| Set control | Pair identity, fit check and quantities |
Send these details with your inquiry
- Send an approved connection detail.
- Define matching and trial-fit requirements.
- List fasteners and accessories separately.
Continue with Splice Plate Sets: Pair Identity and Hole Alignment, or send your project requirements for a scope review.
